# Put a sound on a clip, or take a clip's sound out

Use this guide when a clip needs a voice-over, a music bed or a generated line, or when you want to change a clip's own sound before you put it back. You will make a clip that carries the sound you chose.

## Before you start

You need a video in Canvas and, for Add Audio, a sound: an imported audio file, a Models audio tile such as ElevenLabs Speech, or an Extract Audio node. Both nodes are in **Toolbox**, under **Editing**.

## Put a sound on a clip

1. Add **Add Audio** from **Toolbox** &gt; **Editing**.
2. Connect your video to **Clip**.
3. Connect a sound to **Sound**. Connect a second sound to **Sound 2** to mix two sounds together.
4. Choose **Mode**. **Replace the clip's sound** uses only the wired sounds. **Mix with the clip's sound** keeps the clip's own sound under them, at **Clip's sound level (dB)** (from −60 to 6, −6 by default).
5. To start the sound later, set **Start the sound at (ms)**. The front stays silent until then.

You should see the card play the clip with the new sound. The result is always as long as the clip: a longer sound is cut at the end. Download and the next node receive this clip. With no sound connected, the clip passes through unchanged.

## Take a clip's sound out

1. Add **Extract Audio** from **Toolbox** &gt; **Editing**.
2. Connect your video to **Clip**.

You should see a sound player on the card. The sound keeps the clip's sample rate and channel count. Connect it to any node that takes a sound, then connect the result back into **Add Audio** to put the changed sound on the clip.

## Check and fix

The card says what it is waiting for: a clip, a sound, or the bake. If Extract Audio says it could not get the sound, the clip has no sound track; wire a clip that has one. If a bake fails to save, the card offers **Retry**.

## Ask your agent

> Help me put this voice-over on my opening clip. First, inspect the File and find the clip and the sound. Wire them into an Add Audio node, run it with node_run, and ask before you replace the clip's own sound.

Your agent runs both nodes with `node_run` and polls `node_run_status`. Extract Audio on a clip with no sound ends with `no-audio-stream`.

## Related pages

[Builder guide](/docs/mcp/build) and [Stories](/docs/concepts/stories).

---
Source commit: 9ccaa86d41d7 · Build date: 2026-11-17T03:27:39.423Z
