Put a sound on a clip, or take a clip's sound out
Contents
Use this guide when a clip needs a voice-over, a music bed or a generated line, or when you want to change a clip's own sound before you put it back. You will make a clip that carries the sound you chose.
Before you start#
You need a video in Canvas and, for Add Audio, a sound: an imported audio file, a Models audio tile such as ElevenLabs Speech, or an Extract Audio node. Both nodes are in Toolbox, under Editing.
Put a sound on a clip#
- Add Add Audio from Toolbox > Editing.
- Connect your video to Clip.
- Connect a sound to Sound. Connect a second sound to Sound 2 to mix two sounds together.
- Choose Mode. Replace the clip's sound uses only the wired sounds. Mix with the clip's sound keeps the clip's own sound under them, at Clip's sound level (dB) (from −60 to 6, −6 by default).
- To start the sound later, set Start the sound at (ms). The front stays silent until then.
You should see the card play the clip with the new sound. The result is always as long as the clip: a longer sound is cut at the end. Download and the next node receive this clip. With no sound connected, the clip passes through unchanged.
Take a clip's sound out#
- Add Extract Audio from Toolbox > Editing.
- Connect your video to Clip.
You should see a sound player on the card. The sound keeps the clip's sample rate and channel count. Connect it to any node that takes a sound, then connect the result back into Add Audio to put the changed sound on the clip.
Check and fix#
The card says what it is waiting for: a clip, a sound, or the bake. If Extract Audio says it could not get the sound, the clip has no sound track; wire a clip that has one. If a bake fails to save, the card offers Retry.
Ask your agent#
Help me put this voice-over on my opening clip. First, inspect the File and find the clip and the sound. Wire them into an Add Audio node, run it with node_run, and ask before you replace the clip's own sound.
Your agent runs both nodes with node_run and polls node_run_status. Extract Audio on a clip with no sound ends with no-audio-stream.
Related pages#
Builder guide and Stories.